Installation Instructions:

1. Examine units (remove cap and shake to make sure parts are moving OR press inner parts between fingers until parts are moving.
   
2. Use Teflon tape for threads, wrap as needed to seal threads.
   
3. Remove all eyeball units from pool lines.
   
4. Install valves without caps
   
5. Use wrench (included) no other tool required (hand tighten only) - Use 3/8" drive to loosen in case of over tightening.
   
6. Blow out lines with air compressor. (Requires 20 to 30 psi max.)
   
7. Lubricate caps with any water based lubricant (Hydra Slip Lubricant recommended.)
   DO NOT USE OIL BASED LUBRICANT.
   
8. Snap cap on unit, press on center to fit in place, rotate cap over unit 3-4 times to optimize seal & press center.

Next Season Instructions:

1. Wash unit in warm soap and water to remove old lubricant.
   
2. Re-lubricate unit.
   
3. Follow insturctions 1 through 8 from above.

Special Notes:

In case of pre-existing leaks, cracks or holes in the pipelines, the use of anti-freeze is highly recommended.

This Product Does Not Winterize your Skimmer. See your skimmer's manufacturers instructions.

AT START OF SWIMMING SEASON REMOVE VALVE & STORE IN COOL DRY PLACE. AVOID LEAVING IN DIRECT SUN.

ONE YEAR WARRANTY FOR VALVE COMPONENTS FROM DATE OF PURCHASE. FAILURE TO FOLLOW INSTRUCTIONS VOIDS WARRANTY. NO REFUNDS. EXCHANGES ONLY. YOU MUST SEND A RECEIPT TO: GIGIT INC 415-K BELDEN AVE., ADDISON, IL 60101. CUSTOMER WILL PAY SHIPPING & HANDLING CHARGES.

NO OTHER WARRANTIES. To the maximum extent permitted by applicable law, Gigit Inc. disclaims all other warranties and conditions, either express or implied, and in no even shall Gigit Inc. be liable for any special, incidental, indirect or consequential damages whatsover arising out of the use of the valve system. Gigit Inc. is not liable for any damages due to any defects outside of Gigit Inc.'s control, such as preexisting leaks in the pipes/lines.